|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Clutch basket replacement
Looks like it's time to replace the clutch basket. Any tips for doing this? Looks like a fairly straight forward job. I'm hoping I can do it in a couple hours. I'm guessing the rubber parts in the drive gear are worn too - is it possible to buy the basket with a drive gear installed already or am I better to put the existing gear on the new basket?
|
#2
|
|||
|
|||
I think they come as a unit and you pay for it.
|
#3
|
|||
|
|||
if your basket isnt super bad just replace the rubber dampers, i did it to mine and its been working fine. i also didn't rerivet the the drive gear i tapped out the rivet holes and used buttonhead allens ,it will make replacing the dampers much easier the next time.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
clutch basket mod | stainlesscycle | Enduro Engine - 2 stroke | 5 | 02-09-2010 10:12 AM |
Tools for clutch basket replacement | SpeedyManiac | Enduro Engine - 2 stroke | 4 | 09-19-2009 07:04 PM |
125 clutch basket | GasGas | Enduro Engine - 2 stroke | 1 | 09-08-2008 10:46 PM |