|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How to remove main bearings and seals?
What's the best way to remove the main, crank beaing seals and the left side bearing? Screwdrivers? Special seal removing tools? I would like to hear how others are doing this.
Thanks, Eric
__________________
Eric P. SoCal MC AMA D-37 2004 KTM 400 EXC | 2001 GG 250 MC | 2001 GG 200 EC (wife's) | 2000 Montesa Cota 315 | 1967 Lambretta Li 125 "Special" |
#2
|
|||
|
|||
When I have done this I use a heat gun on the case, then punch out the seals with a wooden punch or dowel.
|
#3
|
|||
|
|||
The seals should come out with a screw driver I have baked the cases at about 300f for 20 mins. Take out with some hot mitts and slap the case on a cookie sheet the bearings will fall right out.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how do you remove the kickstart | noobi | Enduro Chassis & Body | 13 | 09-22-2011 03:31 PM |
Sealed main bearings? | hallam76 | Enduro Engine - 2 stroke | 25 | 03-16-2011 09:26 PM |
99 ec300 front wheel bearings and seals | barbwire44 | Enduro Chassis & Body | 3 | 04-01-2009 03:51 PM |
Remove front axle | BULTACOBRIS | General Discussions & Announcements | 2 | 03-10-2009 10:28 AM |
Periodically remove and re-fit all bolts? | stay_upright | General Discussions & Announcements | 2 | 01-14-2008 07:56 PM |