#1
|
|||
|
|||
Start up after rebuild
Any tips for getting an 03 EC300 started after a rebuild.It did run for a few seconds on the 4th or 5th kick,after i switched the choke and fuel off and wound the throtle to the stop.Don't think there's much wrong,got good sprark and plug is full of fuel when i take it out after a good kicking.I've been kicking/changing plugs all afternoon.
I have fitted a s/hand carb from a dealer,that i have cleaned and set float hight,it's fine as far as i can tell. I put a small amount of pre-mix with a bit of fuel in the plug hole while the bike was sitting around waiting for other jobs to be done,i think that is what's coming from the p/v breather now. Any thoughts? |
Tags |
2 stroke |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PWK rebuild kit | motogroove | Enduro Intake/Carburetion - 2 stroke | 6 | 07-19-2011 06:48 PM |
Need help on top end rebuild | rpduc | Enduro Engine - 2 stroke | 17 | 03-26-2009 11:05 PM |
05 rebuild | brains | Enduro Suspension | 2 | 07-22-2008 08:54 AM |
Rebuild | steve | Enduro Engine - 2 stroke | 8 | 01-13-2008 03:06 PM |