|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2011 EC250 Won't Start After Rebuild
Hi All
So I've just rebuilt my 2011 EC250. Apart a stubborn gasket supplier who insisted gaskets for 2002 - 2011 are all the same, it all went pretty well. Until I tried to start it. It's had nearly everything new, crank bearings, seals, conrod, piston, re-coated cylinder etc. This is what it sounds like when I try to start, just nothing there at all. https://youtu.be/D5_LoQ485ZM I also re-did quite a bit of the dogdy wiring, so I was concerned about that, but the spark looks ok: https://youtu.be/CnPv9xeM_gQ I haven't touched the carb, it seems to be getting fuel as the plug was wet. It's been a long day so it's probably something simple, but I can't help thinking it's something deeper that I fecked up..... Spark + Fuel + Compression = Bang Bang right? Any ideas welcome, thanks in advance. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2011 EC250 Clutch Master Cylinder Rebuild Kit | sneaky98gt | Enduro Chassis & Body | 1 | 01-18-2018 08:02 PM |
For Sale: 2011 EC250/300 E-start subframe | F_G | Parts | 0 | 05-23-2014 08:13 PM |
Start up after rebuild | cangy | United Kingdom | 2 | 03-03-2014 06:40 PM |
Start up after rebuild | cangy | Enduro Engine - 2 stroke | 6 | 03-03-2014 01:58 PM |