|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
O-Rings for clutch slave 2018/2019 300's
When I had clutch problems I replaced the slave cylinder and found that it has a piston with one groove.
The new slave, ordered from GasGas with original GasGas part number has a different piston with two grooves and two o-rings (picture below). I would like to have spare o-rings but it seems they are not available through Gasgas. Any ideas? |
#2
|
|||
|
|||
I would use a micrometer to measure the dimensions of the o-ring. You should be able to source the o-rings after you have the correct dimensions.
|
#3
|
|||
|
|||
Yep, already considered that, but it would have been easier to buy them from GG. Obviously they aren't available so that is the only way to go then. Thank you!
|
#4
|
||||
|
||||
Here ya go Doc, BE250622050 clutch piston repair kit, I think it is the seals and the piston as well.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC/GP 300 2018/2019 offset | Doc Brown | Enduro Suspension | 2 | 09-03-2019 02:46 PM |
2018/2019 12v Power Connector | RudolfHucker | Enduro Electrical & Wiring | 4 | 01-20-2019 02:08 AM |
will 2019 map switch fit 2018 | Doc Brown | Enduro Electrical & Wiring | 13 | 12-27-2018 08:44 AM |
clutch slave | vwboomer | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 06-12-2012 04:04 PM |
Oil around Clutch Slave | rickster2 | Enduro Engine - 2 stroke | 5 | 08-29-2006 11:27 AM |