|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#11
03-25-2012, 11:43 AM
|
||||
|
||||
This relation between mm before top dead center and rotation degrees in flywheel change with the connecting rod angle. So, this is not an good method. To do the movie below, i see that near TDC this relationship change very quick. Try to use one kind of scale thru the spark plug hole at least to check if the degrees math/measurement is ok.
http://youtu.be/XkJQsVgMTLE
__________________
www.endurohp.eng.br Sherco ST300 2015 (Trials) https://www.instagram.com/leocm74/ Brasil! 
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PV timing? | Fred1956 | Enduro Engine - 2 stroke | 3 | 04-14-2011 11:40 AM |
| Timing a 450? | iancp5 | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 05-28-2010 10:17 AM |
| 07 timing? | wence | Enduro Electrical & Wiring | 15 | 10-28-2009 03:42 AM |
| Need HELP with timing | gasser | Enduro Engine - 2 stroke | 2 | 03-23-2009 02:17 AM |
| For all who know Timing?? | nwcycle | General Discussions & Announcements | 0 | 03-21-2009 11:25 AM |
Linear Mode
