|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
clutch plates
does anybody know what the thickness of the Gasgas friction plates are? i just bought a cr 250 basket case , and long story short i took one of the clutch plates and matched it up with the Gasagas plate and it was perfect, but i would like to know the thickness of the Gasser plate so i can measure the 2 before i order a set, if it works it will save a little bit on clutch plates, i priced a set of Cr plates at$ 60.00 verues the Gasser plates at $ 125.00
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
broken clutch plates? | stainlesscycle | Enduro Engine - 2 stroke | 24 | 09-27-2011 04:39 AM |
steel clutch plates | steve | Enduro Engine - 2 stroke | 3 | 03-15-2011 09:22 PM |
new clutch drive plates | dank | Enduro Engine - 2 stroke | 4 | 06-23-2010 11:15 AM |
New DP clutch plates won't fit - suggestions? | stay_upright | Enduro Engine - 2 stroke | 6 | 05-26-2008 09:59 AM |