|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
silencer tips
Is it imperative that the silemcer tip be riveted onto the core of the silencer? I have had a number of rivets fail (most likely poor installation at the shop?) on my FMF Power Core 2 Silencer over the last couple of months and was considering other mechanical fasteners. Any suggestions.
|
#2
|
||||
|
||||
Bolts work fine.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
13 free GASGAS set up tips on www.scottysdirtbikespares.com | gasgasandrew | General Discussions & Announcements | 0 | 08-20-2009 04:38 PM |
First enduro ever...tips/suggestions? | sled_fiend | Off Road Racer's Corner | 8 | 07-10-2009 08:55 AM |
GasGas Service & Setup Tips | MattR | General Discussions & Announcements | 0 | 11-27-2008 08:50 AM |
Winterizing Tips? | gasIdaho | General Discussions & Announcements | 5 | 12-05-2007 10:14 AM |
EC 200 set-up tips needed | bondo | General Discussions & Announcements | 20 | 10-23-2007 01:15 PM |