|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Hi
530mV is way too low. I recommend using volt meter cause guzzidiag is not accurate, it jumps 20 mV. First loosen the screw which had the yellow paint to fully close the throttle blade. Next step is to adjust the sensor on the side of the throttle body so you get minimum 351mV, write down your voltage. Next you add 290mV to the voltage you wrote down, if you had 355mV, 355+290=645mV. 290mV equals 6,5 degree opening on the throttle blade. Next you screw in the hexagon screw until you have added 290mV and reach your calculated number. Last step is to use the program to reset the TPS Hope this will help so you can start her up on first push and without touching the throttle. Sent from my LG-D855 using Tapatalk |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2004 450 FSE starting issues | rodneymj | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 11-17-2014 02:08 PM |
Gas Gas 450 FSE 2003-4 starting Issues | stainless601 | Enduro Engine 4 stroke (including EFI & Exhaust) | 0 | 05-04-2013 11:42 AM |
300 hard starting warm Having some carb issues. | Ed Ventura | Enduro Intake/Carburetion - 2 stroke | 1 | 03-11-2012 08:12 PM |
Hot starting. | nick790 | Enduro Intake/Carburetion - 2 stroke | 0 | 04-21-2010 02:44 PM |
2004 450 FSE Hot Starting Issues- | MTNBK | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 06-30-2009 07:19 AM |