|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ec 300 water in gear oil? O ring ??
Hi I'm new to group, recently got a 2002 ec 300 and see oil was a little milky so decided to do pistonkit and water pump seal , all went fine got back together started up and water still going into gear oil , so have ordered the water pump shaft and another new seal , found this oring on my black mat after finished near the bike dont know if or where this could of come from , any ideas would be great thanks Attachment 9022
|
#2
|
||||
|
||||
I've had to buy a new shaft before where there was a groove. Cheap part.
Water stays in box area so needs a flush. Buy a litre or so of diesel and pour 1/2 in. Prop the wheel up safety so it can spin. start the bike and run in gear for 10 seconds, drain and repeat.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#3
|
|||
|
|||
OK thanks will do, u have any clue where that o ring could be from ?? Thanks
|
#4
|
||||
|
||||
O-ring maybe part of one of the seals?
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
WTB E-Start Ring Gear | shang | "Wanted to Buy" & "Want To Trade" | 2 | 08-13-2019 08:07 PM |
Ring gear | pigpen966 | Parts | 0 | 05-18-2016 09:03 PM |
WTB 2014 e-start ring gear | dANbOT | "Wanted to Buy" & "Want To Trade" | 0 | 07-12-2015 08:36 AM |
WTB Ring Gear or clutch basket | PEB | "Wanted to Buy" & "Want To Trade" | 9 | 11-19-2013 10:46 AM |