|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
05-11-2009, 06:25 PM
|
||||
|
||||
Ratchet spring.
Anybody know if the new kickstarter ratchet springs are fixed (stronger)?
__________________
04 Montesa 315R, 07 EC300, 21 KTM Erzberg 300, 21 Sherco 300 SEF-F, 23 KTM 690, 23 Rieju Mr Pro 300 
|
|
#2
05-12-2009, 07:40 AM
|
||||
|
||||
|
I just changed mine. I also replaced the gears but honestly the original ones did not look much different than new except for a small chip or two, so they are in the spares box not the can. The spring I got from GoFasters was a couple mm longer, not sure if by design or because the old one was starting to sack. It feels the same moving it through the stroke by hand. If it slips again I'll preload the spring with some shims against the case, there is room to play with.
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 48 280 spring.. | jhendr3702 | Enduro Suspension | 3 | 06-09-2010 05:11 AM |
| Spring help | jriley43 | Enduro Suspension | 0 | 05-21-2009 10:54 AM |
| Spring | steve | Enduro Engine - 2 stroke | 2 | 03-03-2008 03:44 PM |
| Rear spring | Wicitup | Enduro Suspension | 8 | 10-02-2007 05:42 PM |
| Spring/Sag ? | skid jackson | Enduro Suspension | 0 | 10-08-2006 09:35 PM |
Linear Mode
