|
GasGas Member Polls Find out what everyone thinks about it! |
View Poll Results: How many Gassers have you owned? | |||
1 | 134 | 43.37% | |
2 | 85 | 27.51% | |
3 | 49 | 15.86% | |
4 | 17 | 5.50% | |
5 or more | 24 | 7.77% | |
Voters: 309. You may not vote on this poll |
|
Thread Tools | Display Modes |
#33
|
||||
|
||||
Hey Jim
The 76mm piston is a Wiseco from Eddie Sanders Racing part number 11505M07600. Wiseco will not sell them to you directly. The application is a big bore for an Honda ATC250. You will need to clearance the bottom of the piston to clear the cases and to match the case transfer port side windows. You will also need to cut down the power valve to clear. Last but not least you will need to weld and recut the head. http://www.eddie-sanders-racing.com/...ston-kits-.htm 76mm was about as big as I could go on the GG 300 cylinder. It was really close and did not leave much margin between new bore and the inner head o-ring groove. Here is some more info on it. http://www.thumpertalk.com/topic/751...s#entry7882216 I spoke with that guy that put the 250 cylinder on the 200. As I recall he said he had to cut the base of the cylinder about 1mm. I set a 250 cylinder on a 200 one time and took a photo. I lost my measurement but as I recall the piston was about 0.04 to 0.045 low in the hole at TDC. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2011 Model Gassers | JRDoz | General Discussions & Announcements | 85 | 09-25-2010 04:55 PM |
white gassers | tm_enduro | General Discussions & Announcements | 13 | 04-04-2009 03:15 PM |
I have two Gassers, but Im helping a friend with his CR 125 | FFRDave | Enduro Engine - 2 stroke | 2 | 12-19-2008 11:29 PM |
Marzocchi-Now U.S. owned. | gasgasman | General Discussions & Announcements | 11 | 09-02-2008 07:25 PM |
Gassers in NC | dmstarr | General Discussions & Announcements | 4 | 11-21-2007 11:44 AM |