|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
twin air power flow kit
Has any one installed this kit? And what are the advantages ? Plastic vs. billet cage? Thanks
|
#2
|
||||
|
||||
Plastic cage OEM, aluminum cage for the TA. The supplied filter uses five locating pins instead of three in the OE set-up. The mating surface is flatter as well.
__________________
Steven Beane #275 PlusOnePerformance - Superior Service the World Over - Dearborn MI AMA District 14 (Michigan) Officer afterhourscycle.com Michigan's Beta and TM Race Headquarters |
#3
|
||||
|
||||
I've been using 1 for years; it makes it easier to mount the filter into the airbox with no gaps--it's stiffer & has extra pins. I just sold it to a GG rider in Norway....
|
#4
|
||||
|
||||
Sounds like a great upgrade.
Question: Can stock filters be used with the new cage? I have a couple of brand new stock filters.... Hate to throw them away in addition to the cost of the new system plus a couple of spare filters.
__________________
Newest Spanish Girlfriend: 2011 300 Six Days My Daughter is a U.S. Marine |
#5
|
|||
|
|||
I have the same dilemma . Does this flow kit exists for the 2011 300s ?
__________________
Vindicator '11 EC 300R |
#6
|
||||
|
||||
I just used the extra pins on the aftermarket cage to punch new holes in the filter elements, worked like a champ.
|
#7
|
||||
|
||||
That will work fine, and filters are the same from '07+.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
98 Twin Air help needed | savage sausage | United Kingdom | 2 | 05-24-2012 02:39 AM |
Coolant flow | Neil E. | Enduro Engine - 2 stroke | 4 | 05-17-2011 11:07 AM |
over flow tank | Silver | General Discussions & Announcements | 9 | 07-25-2009 01:50 PM |
extra coolant flow?? | skid jackson | Enduro Engine - 2 stroke | 5 | 05-15-2008 10:59 PM |
coolant over flow | west aussie gas 450 | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 02-10-2008 04:24 PM |