|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Mine is not cut, just looks like the ribs were sanded off smooth in the center of the lip where it could touch from the factory.
Smear some grease on the top of the filter, install and remove the seat, and you should be able to see the contact area. Any means of trimming plastic should work(dremell, hot knife). Just sand or flame polish it smooth when done. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tire cutting tip | moto9 | Enduro Chassis & Body | 9 | 12-23-2010 11:23 PM |
cutting out at wot | stainlesscycle | Enduro Intake/Carburetion - 2 stroke | 13 | 07-17-2010 08:21 AM |
FSE 450 cutting out | jack1234 | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 04-18-2008 11:20 AM |
Safest/Easiest Way To Carry Trail Cutting Tools... | tprnottp | General Discussions & Announcements | 1 | 01-01-2007 08:05 PM |
cutting the mufler | wmd | Enduro Engine - 2 stroke | 12 | 08-24-2006 02:14 PM |