|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
throttle cable
I have a very embaressing question,so here it goes;I have an 06 EC300 can I have step by step instructions on putting my new Motion Pro throttle cable?Why does it seem to short ,not routing,when attached!?!?When you guys stop laughing please help!Now I no why I sell them and buy new,it is so I don't have to deal with this s**t!I can't even remember when I had one co
mpletly off a bike!!!!!!!!!!!!! Sorry for the rant,but this thing is handing me my ass!!!!!! |
#2
|
||||
|
||||
Here are a couple pics with some arrows of the routing. It's easier to see then try to describe in words.
Route the cable in front of the handle bar clamp: Route the cable down the left side frame (between radiator and frame). Then, it connects smoothly with the carb. NOTE: When you connect the inner cable to the carb slide, make sure you have the inner cable end in the slot and the plastic spring seat tab correctly in the slot (to keep the cable located there). You will see this when you have the carb slide out.
__________________
Matt Current: 2009 Yamaha FZ1 Previous: 2001 GasGas TXT280, 2001 GasGas XC250, 2004 KTM 200EXC, 2007 GasGas EC250, 2007 Husqvarna SM610, 2008 Husqvarna WB165 |
#3
|
|||
|
|||
Thanks for the tip!!!!!!!!
|
#4
|
||||
|
||||
Step 1: Simply remove throttle cable.
Step 2: Installation-Reverse removal procedure. |
#5
|
|||
|
|||
Wow! I thought my bike was clean, it' a dirty pig compared to that.
|
#6
|
|||
|
|||
Done!The problem was the plastic protector for the cable adjuster on the perch needed to be hogged out.It was holding up the cable sheath from going to the adjuster thus depriving the slack I needed.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Throttle cable / slide | Gassey fan | Enduro Intake/Carburetion - 2 stroke | 4 | 03-04-2009 11:23 AM |
Throttle Cable | steve | Enduro Intake/Carburetion - 2 stroke | 5 | 02-14-2009 02:39 PM |
Throttle cable | dave948 | Enduro Intake/Carburetion - 2 stroke | 7 | 10-10-2008 04:16 PM |
Throttle Cable Crossover | Ed Ventura | General Discussions & Announcements | 8 | 08-29-2008 05:55 AM |
Placement of Throttle Cable | John_B | Enduro Engine 4 stroke (including EFI & Exhaust) | 12 | 07-02-2007 08:21 PM |