|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Throttle sticking
Last weekend I went riding with a few friends of mine. Anytime I went through a whoop section or hit a rocky section at mid throttle or higher my throttle would get stuck open. Each time it did it I would pull the clutch in and romp on the throttle, which would free up my throttle. I have taken my carb. out to see if maybe the slide was sticking on something, but have not found anything that would cause it to get stuck. Also checked the throttle cable, and it was working properly. (I went ahead and oiled the cable) Is there something else that I am missing that would give me this problem.
|
#2
|
||||
|
||||
Broken slide return spring? Cable frayed inside the housing? Pulley binding in the throttle housing?
|
#3
|
||||
|
||||
if none of that works - check your throttle tube/grips - grip could be binding on bark busters (if you have them...)
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#4
|
||||
|
||||
Depending on the cable routing - you can also have the cable pull out of the adjuster and hang up on it. Safety wire cable to adjusters at each end of throttle cable to avoid this issue.
jeff
__________________
|
#5
|
||||
|
||||
Needle jamming in nozzle from sand/dirt in float bowl. It doesn't take much.
|
#6
|
|||
|
|||
Check the routing first since its the easiest. Give a yank on the cable and see if anything happens and make sure there is some slack. I stuck a bottle of water behind my headlight once and it caused it to rev up out of control.
__________________
2006 EC300, 2000 XR650R, 2003 EC250, 2001 EC200 (OK, the last two are really my sons). |
#7
|
||||
|
||||
thanks for everyone's reply. I will try all of yall suggestions and get back to yall.
|
#8
|
|||
|
|||
What was the outside air temp. and humidity ? Carbs. can ice up when the air temp. is above freezing.
Wrapping the carb. in bubble wrap, or something, is a quick fix for cold weather riding. Even better is to channel warm air from the engine. Last edited by Brian VT; 01-21-2011 at 07:10 AM. |
#9
|
|||
|
|||
Quote:
http://www.kevinscycleracing.com/ click carb/intake on menu on the left |
#10
|
||||
|
||||
Mine will do that occassionally when going over whoops or bumps .
May look into those filters. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sticking throttle | skid jackson | Enduro Intake/Carburetion - 2 stroke | 8 | 11-15-2010 08:44 PM |
Sticking Throttle | SeanUK | Enduro Chassis & Body | 5 | 12-09-2008 01:27 PM |
Kick starter sticking | jyellard | Enduro Engine - 2 stroke | 5 | 11-19-2008 04:44 PM |
Different Throttle Springs?? | stvbird | Enduro Intake/Carburetion - 2 stroke | 13 | 10-15-2008 08:17 AM |