Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.

Thread Tools Display Modes
Old 03-31-2011, 02:04 PM
jdosher jdosher is offline
Join Date: Feb 2011
Location: Seattle, WA
Posts: 56
Question Clutch springs

Does anyone know of clutch springs that have a lower spring constant (or are shorter) than the stock Gas Gas clutch springs? Possibly 06 YZ250F?

I've recently put a Revloc Dyna Ring into my 09 EC300. Part of the dyna ring install is to add a number of shims/thrust washers on top of the needle plate to push the pressure plate out and create a gap. All told, the springs get compressed about 2mm from stock, and this has caused the clutch to lose its nice, light pull.


Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
springs Gasgasogeros Enduro Suspension 9 01-04-2010 06:14 AM
What springs should I use? 2 strokes 4 life Enduro Suspension 11 03-21-2009 09:22 PM

All times are GMT -5. The time now is 11:52 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org