|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Rebound shim recommendations (stiffer)
Any recommended shim stacks for my 2005 EC300. I want to try and stiffen up the rebound - probably lower speed specifically.
What's in there now? If I remember correctly the rebound stack is quite simple (3 shims?)
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
#2
|
||||
|
||||
***********woosh******************
(tumbleweed)
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
#3
|
|||
|
|||
I think it has (3)21x.10? Maybe try this with 5wt oil?
21x.15 17x.10 13.10 |
#4
|
||||
|
||||
Stock:
21 x .1 19 x .1 17 x .1 15 x .1 From Pobit (Dave): 22 x .1 22 x .1 19 x .1 19 x .1 18 x .1 17 x .1 15 x .1 With 7.5 W oil. Makes a nice difference. |
#5
|
|||
|
|||
Right now i´m using a stack as follows:
21 x .1 21 x .1 19 x .1 19 x .1 17 x .1 17 x .1 15 x .1 And it´s a great upgrade over the stock one however with stock springs it´s a bit too much since i can only ride with 5 clicks on. I´m waiting for my 0,45 springs and will report back then. The pobit stack looks promising but i´m not a fan of 22mm shims. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rear wheel bearing shim spacer dimensions? | mattlloyd50 | Enduro Chassis & Body | 17 | 07-24-2010 10:13 AM |
45mm zoke shim id | Ed Ventura | Enduro Suspension | 1 | 09-22-2008 05:34 AM |
05 EC250 Marzocchi stock shim arrangement ? | ferguscawley | Enduro Suspension | 10 | 01-10-2008 07:49 AM |
Need your recommendations for my next bike | MattR | General Discussions & Announcements | 34 | 08-25-2006 08:08 AM |