|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2000 Xc 250 wont start In mesa arizona
Ok here we go,
My bike will not start, here is the run down of what Ive done and any help you have to offer would be needed. 1 kick it over for a million times 2 drain all gas and put fresh pre mix in it 3 changed plugs 4 held new plug outside against head to look for spark,( no spark ) Backround A week ago road it for 20 mins on this little trail close to my house Was puting on the trailer and a strap broke bike fell over on the right side. I went to go riding this week no start. The kickstarter feels a little different but that could be me, looked for loose wires dont see any. Could the coil have gone bad, could the kill switch be acting up, has a stator ever been knocked loose, where to start any help.(Oh ya going to gordens well in 2 weeks gotta have the gas gas) Thanks Justin Last edited by justinmanus; 10-27-2006 at 10:39 AM. Reason: typo's |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2005 FSE450 wont start | itsagas | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 05-16-2010 08:38 AM |
EC200 kick start lever (2000 model) | sireid | Enduro Chassis & Body | 11 | 01-24-2010 02:56 AM |
02 EC 300 wont start | GENO 300 | Enduro Engine - 2 stroke | 0 | 09-21-2009 10:02 PM |
EC200 wont start | Skele | Enduro Engine - 2 stroke | 25 | 09-06-2009 10:34 AM |
wont start | clerky clerk | Enduro Engine - 2 stroke | 8 | 11-01-2008 01:18 PM |