|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
NECJ #2
MJ 175 PJ 42 AS 1 1/4 1000ft alt 65 - 85 degrees f. 95-98 octane gas
__________________
EC300 2019 (11 Gassers owned, many more to go) |
#2
|
||||
|
||||
Thanks Keg I will give it a try.
Went out today with 178 Main 45 pilot #1 standard clip AS 2turns out And had a bog off of idle Thanks for the help Martin
__________________
2018 EC 300 |
#3
|
|||
|
|||
Quote:
NEDW #3 for the GP300 is pretty good too.
__________________
EC300 2019 (11 Gassers owned, many more to go) |
#4
|
|||
|
|||
Now my EC 300 2018 work perfect with NEDW at 3
MJ 172 PJ 42 AS 1 1/2 Alt sea level 5-15 degrees C. 95-98 octane gas but remove this damn cable choke, it is the cause of the majority of the problems |
#5
|
|||
|
|||
I was also told to ditch the choke. Plan to do that as well.
__________________
2018 XC300 |
#6
|
|||
|
|||
Hi, since the last reprogramming of the CDI, I have the slow motion which remains a little elevated before falling back, have you noticed the same thing?
NEDW 3 MJ 172 PJ 42 AS 1 1/2 Alt niveau de la mer 20 degr?s C. Gaz ? 95-98 octane |
#7
|
||||
|
||||
2018 Ec 300. Installed a pull choke. 0-1000 feet
AS 1.5 turns 42 P NEDW 2nd clip position. Still had a slight burble on the 3rd position. 175 Main Working very well in the drive way but need to trail ride it tomorrow.
__________________
2018 EC 300 Last edited by GasGas; 09-28-2018 at 08:07 AM. |
#8
|
||||
|
||||
Bike worked fantastic today. Mind you it's cooling off here now. About 15C here today.
__________________
2018 EC 300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Revised Jetting Specs NEDW | Jakobi | Enduro Intake/Carburetion - 2 stroke | 197 | 09-19-2014 08:17 AM |
'06 EC300 stock handlebar specs? | brider | Enduro Chassis & Body | 0 | 09-16-2013 03:08 PM |
What is the stock 200 needle and jetting specs | shaheeb | Enduro Intake/Carburetion - 2 stroke | 3 | 03-24-2012 10:56 PM |
2010 EC300 Factory Jetting Specs - WTF? | JP4 | Enduro Intake/Carburetion - 2 stroke | 197 | 07-04-2011 11:03 AM |