|
|
|||||||
| Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
 |
|
|
Thread Tools | Display Modes |
|
#1
02-26-2011, 12:57 PM
|
|||
|
|||
Removing stock handguards & lever bolts 2011
I have a new 2011 250 6-Days and I removed the useless stock handguards and I am installing real aluminum handguards.
What has everyone done about the clutch and brake lever bolts that are specific to the original plactic guards? The stock bolts are now too long and the washers and spacers are too long or too large, there is now no sort of rubber front brake boot/dust seal, there is slop in the lever, etc... Please help! Thanks. 
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Torquing Bolts | wbagwell | Enduro Engine - 2 stroke | 7 | 06-10-2014 07:36 AM |
| Modded 2005 DE250 vs Stock 2011? | AZRickD | General Discussions & Announcements | 1 | 01-10-2011 11:29 PM |
| Handguards | roostafish | General Discussions & Announcements | 0 | 07-30-2007 07:02 PM |
Linear Mode
