|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Filling new radiators
Is there a right way? I don't know if I'm doing it right...
|
#2
|
||||
|
||||
Nah. Just fill them up till they're over the fins. Can lay the bike a little to each side, but generally just start the bike with the cap off to start with. It might spit out an air bubble. Top up over the fins again. Check for leaks.
|
#3
|
|||
|
|||
Cool- thanks. I didn't think there could be more to it than that. I put new rads on both sides and it took a little less than a half gallon of coolant. Now to get it to idle again...
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Radiators | papa_j | Enduro Other... | 4 | 03-13-2013 09:28 PM |
Radiators | savage sausage | Enduro Chassis & Body | 0 | 09-25-2011 06:45 AM |
Radiators???? | Bambam | Enduro Chassis & Body | 2 | 09-22-2011 08:07 AM |
Radiators | Warwick Simpson | Enduro Chassis & Body | 4 | 09-18-2010 03:02 AM |