|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Plastic cylinderbase gasket?
When i renovated my 250 03 engine i bought a gasket Pack from Athena. In the Pack i found 3 cylinder foot gaskets. 1 thick Greyish gasket, one ,35mm green gasket and a ,10mm gasket(?) Made of something That looks like see through plastic. Is this Even a gasket or something Else?
|
#2
|
||||
|
||||
I wasn't sure either, stuck it in anyway in between the other 2, no problems with it leaking or melting.
__________________
02 300ec- 50mm Marzocchi cc forks, 2010 plastic. Now a 250cc. |
#3
|
||||
|
||||
Quote:
The 3rd one or the thinest should be I think a 3mm gasket....If I remember right.
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#4
|
|||
|
|||
Could it be used on its own you think?
|
#5
|
||||
|
||||
don't see why not> http://www.athenaparts.com/eng/model...gas-gas-ec-300
the different thickness base gaskets are used to move the cylinder up or down in relation ship to the top of the piston and the ports when the piston is BDC
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#6
|
|||
|
|||
Just a bit akward to use a plastic thing in the middle of the engine
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
07 gasket kit into a 09? | lonetree | Enduro Engine - 2 stroke | 3 | 07-10-2014 12:14 PM |
Gasket Set. | Marki | Enduro Engine - 2 stroke | 3 | 12-02-2011 06:15 PM |
Base Gasket re-use? | motogroove | Enduro Engine - 2 stroke | 5 | 06-26-2011 07:56 PM |
Base gasket | Ud_luz | Enduro Engine - 2 stroke | 21 | 05-09-2008 07:38 AM |
Base Gasket | gtsnowcrack | Enduro Engine - 2 stroke | 6 | 09-09-2006 05:43 AM |