Cycra hand guard mounting options

[thejackrabbit]

I'm dead set on cycra pro bend hand guards, unless something better is out there but as seeing how i can't use the triple clamp mounts IMO the sturdiest ones because of the inset hex key bolts. I wanted to hear your opinion/experiences with mounting these guards. should I just go with the conventional bar clamps? I have 1/8th bars. I know there are a few other options for mounting besides those two, but I've never used them to know if they work or not

your knowledge is greatly appreciated

[roverhybrids]

I have fastway FIT system.

Im not understanding why you can't use tripleclamp mounts?

[thejackrabbit]

i can't use mounts like the ones in the picture

because my bike doesnt have 10-12mm bolts it has counter bored hey key bolts

these are the mounts that I would prefer to use

[Anders]

I use the Cycra CRM mounts. Works good, and provides easy routing of cables etc.
http://store.cycraracing.com/ceremo.html

[Brian]

Originally Posted by Anders

I use the Cycra CRM mounts. Works good, and provides easy routing of cables etc.
http://store.cycraracing.com/ceremo.html

I'm using those as well. Makes for a tight fit on the fork adjustment clickers, you really can't make any adjustment with them on. I end up removing the bars to make any adjustment. Also had to do a bunch of trimming on the bar pad, even with that the velcro bit barely reaches around the pad/bar.

I don't see any better option than these though. It didn't seem like the triple clamp mounts would work to me either.

[Anders]

Originally Posted by Brian

I'm using those as well. Makes for a tight fit on the fork adjustment clickers, you really can't make any adjustment with them on. I end up removing the bars to make any adjustment. Also had to do a bunch of trimming on the bar pad, even with that the velcro bit barely reaches around the pad/bar.

I don't see any better option than these though. It didn't seem like the triple clamp mounts would work to me either.

I am actually able to adjust the clickers on my KYBs, however I use a Scott sub mouted damper, hence the bar is raised compared to stock position.

Sent from my GT-I9505 using Tapatalk

[nambo-trev]

I used pro bends with bike bonz mounts, they work great and I like how they integrate and act as the top bar clamp too. They make the hand guard un twistable as I had problems with others moving in hard get offs. If you want a set I have a pair since I moved to the twisted engineering bars, I can't use them with there system

[eff]

Get the CRM - Center Reach Mount hand guards. http://store.cycraracing.com/ceremo.html

They work great.

[StuJohnson]

These guy make killer bark busters and they also make some nice custom top bar clamps that the Cycra's can connect to.

I don't personally have these but have heard nothing but positive things about them.

http://www.highwaydirtbikes.com/HDB_...5k5hxi45ke80w6

[Darrendeep6]

You should check out BRP for their mounting solution. They have bar clamps that replace the OEM ones and have mounts on them. I use them and with threaded bar inserts they are tough. I have taken many saplings out with them.

http://brpmoto.com/products?page=sho...tegory_id=1386