|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Bearing Removal?
Since I have sent my forks and rear shock to Les to be serviced I decided to clean and grease all bearings on my bike.
So yesterday I tore the swing arm off and cleaned and re greased it. I had one pivot point that looked a bit dry but after cleaning it and repacking it it should be fine. I removed the steering stem and cleaned the top bearing and repacked it. The lower bearing seems to be pressed on and I can't get the darn thing off. I cleaned the bottom bearing and repacked it as best as I could but when I put it all back together it felt rough when turning the bars from side to side so I think it would be best to replace both bearings. So how do I remove the lower bearing and do I have to press a new one in? Help a Brotha Out! Boom
__________________
Bikeless for Now Thanks to Smith's Powersports 724-899-3375 www.smithspowersports.com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flywheel Removal | BOBBYPRUIETT | Enduro Engine - 2 stroke | 3 | 04-08-2010 12:16 AM |
Carb Removal | carlg | Enduro Intake/Carburetion - 2 stroke | 13 | 02-03-2010 03:15 AM |
Front Wheel Bearing Removal | coolum74 | General Discussions & Announcements | 13 | 02-24-2009 03:29 PM |
Airbox Removal | gasIdaho | Enduro Chassis & Body | 2 | 02-13-2009 12:37 PM |
Dent Removal | PEB | Enduro Engine - 2 stroke | 7 | 12-27-2007 09:23 PM |