rear wheel bearing shim spacer dimensions?

[mattlloyd50]

hi does anyone know the dimensions of the spacer that fits between the two wheel bearings on the sprocket side. its like a big washer. i have ordered one but need it before the two week delivery date.
thanks for any info. matt

[darren]

What bike have you got?

Is it a Talon hub or a Original GG

[mattlloyd50]

sorry. its a gas gas ec250 with the standard wheels with 2 6004 bearings and 1 6005.
thanks

[darren]

Originally Posted by mattlloyd50

sorry. its a gas gas ec250 with the standard wheels with 2 6004 bearings and 1 6005.
thanks

I have an old wheel that i could knock the bearings out and measure up but i could not do it until the morn (Fri) is that too late

It is off a 98 GG not sure if it is the same as yours.

My other wheels are talon hubs which i suspect will be different.

[mattlloyd50]

no thats not too late im grateful that you are willing to do this.
thanks very much.
would you like to sell the spacer and the circlip from the other end?

[darren]

Originally Posted by mattlloyd50

no thats not too late im grateful that you are willing to do this.
thanks very much.
would you like to sell the spacer and the circlip from the other end?

I am sure we can sort something out. How soon do you need the parts,

[mattlloyd50]

i was hoping to go out on it next weekend so we have a week to sort something out.
thanks again
my email is

mattlloyd50@tiscali.co.uk

[darren]

Originally Posted by mattlloyd50

i was hoping to go out on it next weekend so we have a week to sort something out.
thanks again
my email is

mattlloyd50@tiscali.co.uk

Ok I think you are as bad as me I can never wait for the parts to arrive either.

I will e-mail you tomoz

[Keg]

I just ordered a 4mm wider inner bearing for mine and shaved 1mm off the outer spacer. I even put the 7mm seal back in and it seemed to work, even though I had a 6mm one for it.

[gasgasman]

FYI-The inner spacer keeps the side pre-load off the inner bearing race when you tighten the axle nut.