|
|
|||||||
| Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
 |
|
|
Thread Tools | Display Modes |
|
#1
10-10-2009, 02:20 AM
|
|||
|
|||
Outer diameter of Sachs fork at the triple clamps
Hi!
Could somebody give me some measurements for the outer diameter of the Sachs '09-'10 forks at the triple clamps? Above and below the bolts. Thank you! Leon 
|
|
#3
01-20-2010, 03:35 PM
|
|||
|
|||
|
Actually,, what are the diameter of the fors for all four common inverted that gg used,, zokes 45 inverted(54 top?), 43wp(54top 57bottom?) Ohlins, and sachs??
__________________
Steve 16 Beta 350rr 04 KTM 525 sx/exc gone 03 KTM 625 sxc-rehab unit-did its job and now gone 03 GG 250 ec-gone 97 GG 250 ec Gone
|
|
#4
01-20-2010, 06:21 PM
|
||||
|
||||
|
Sachs Forks OD at Clamps
Top spec'd at 54.0mm; land at bottom clamp is 59.3mm for Sachs forks.
__________________
Steven Beane #275 PlusOnePerformance - Superior Service the World Over - Dearborn MI AMA District 14 (Michigan) Officer  afterhourscycle.com Michigan's Beta and TM Race Headquarters
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Milling out triple clamps? | Cruiser | General Discussions & Announcements | 3 | 01-20-2010 08:53 PM |
| Bitchin' triple clamps available?! | robinator | Enduro Suspension | 0 | 05-08-2009 09:43 PM |
| Triple Clamps clearance- Does this looks right?! PIX INSIDE | alexpp | General Discussions & Announcements | 8 | 04-15-2009 09:14 PM |
| wp or zokes diameter at clamps? | Cruiser | Enduro Suspension | 4 | 04-21-2008 06:20 PM |
Linear Mode
