01 200 Ohlins fork seal ?

kendunn · #1 09-25-2011, 05:30 PM

My seals are shot on my 01 EC200 and a little confused about the seal. Everyone lists back to 03, but they appear identical to my newer Ohlins, even did some measurements of the tubes and housing and they seem identical. Am I missing something? Maybe someone put newer forks on this? Maybe listing just doesn't go back that far? Ideas?

Synergy-Seals · #2 09-28-2011, 12:31 PM

Quote:

Originally Posted by kendunn

My seals are shot on my 01 EC200 and a little confused about the seal. Everyone lists back to 03, but they appear identical to my newer Ohlins, even did some measurements of the tubes and housing and they seem identical. Am I missing something? Maybe someone put newer forks on this? Maybe listing just doesn't go back that far? Ideas?

I beloved those are 46mm. I have plenty of them available.

Rob

kendunn · #3 10-08-2011, 03:37 PM

Ends up I had 43mm forks and that was throwing me off.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
fork seal replacement wp 43	dank	Enduro Suspension	1	05-01-2010 03:50 AM
Fork Seal Tune up	MIKEWA	Enduro Suspension	4	08-30-2009 04:27 PM
01 SE 300 with Ohlins Fork seal question	forgiven	Enduro Suspension	2	07-10-2009 02:17 PM
fork seal change	skid jackson	Enduro Suspension	8	06-05-2009 01:42 AM