|
|
|||||||
| General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#2
06-18-2008, 09:34 AM
|
||||
|
||||
1) Get an electric glue gun and fill the hole. Put the screw back in place and tape in place until glue sets up.
2) Buy a "fatter" sheet rock screw (the key is finding a screw that has very coarse threads) and shorten the length with a grinder so it won't go through the tank. If you go to a larger hardware store you should be able to find a lot of varieties of screws to choose from.
__________________
Steve Berkner I've attended 21 Six Days as a working Photojournalist 
|
|
#3
06-18-2008, 11:19 AM
|
||||
|
||||
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| seized shroud screw in Clark oversize tank | jostby | General Discussions & Announcements | 6 | 12-13-2009 02:49 PM |
| right side PV vent stripped....help | joey11 | Enduro Engine - 2 stroke | 5 | 06-20-2009 02:38 PM |
| Stripped bottom of Ohlins | prk03 | Enduro Suspension | 8 | 01-25-2009 09:03 PM |
| stripped hex head | nhrider | General Discussions & Announcements | 11 | 05-28-2008 12:06 PM |
| Stripped | Brian VT | Enduro Suspension | 4 | 12-09-2007 09:06 PM |
Linear Mode
