|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
needles
hi guy just wondering if im doing this JD database correct. i think i am because on the needle profile I can see the 3 tapers or just the single taper. my bike is an 04 ec300 currently running NECJ clip 1 42 pilot 175 main. i feel its too lean but the bike runs well. on reading a lot of older jetting posts it seem that the CCK is pretty good for my era bike. do i have the table correct in that the CCK is a fair bit richer than the NECJ. i dont have a CCK but have a CCK but have a DDJ so i have put that in with on clip 4 which makes it a little richer(less than 5%) pretty much everywhere so if i put a 172 main with 40 PJ its only slighty richer. my main question is am i using the excel sheet correctly with the way im punching the values in?
thx
__________________
19 EC300 Six Days 04 EC300 00 KX125 06 KX450(deceased) |
#2
|
||||
|
||||
I ran a N3EG in my old 04 300 at sea level with similar jets. The J series were very lean in mine as well.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#3
|
||||
|
||||
Also a good needle an old ltr trick ddk worked great in my o2-05 250/300
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Needles, needles, needles... | Terrence R | Enduro Intake/Carburetion - 2 stroke | 28 | 06-26-2015 06:20 PM |
jet needles | gassergrant | Enduro Intake/Carburetion - 2 stroke | 7 | 09-22-2014 12:55 PM |
needles? | clerky clerk | Enduro Engine - 2 stroke | 23 | 10-13-2008 04:06 PM |
needles | moff747 | Enduro Intake/Carburetion - 2 stroke | 4 | 07-09-2008 04:43 PM |
Needles | skid jackson | Enduro Intake/Carburetion - 2 stroke | 5 | 08-17-2007 06:25 PM |