|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
ignition timing on a 2000 XC300
I took my stator apart to inspect and clean for a no spark problem.
I did not mark the position of the backing plate because I assumed there were marks on the case to line it back up. Ya know like every other motor on the face of the planet........ I later found out there is a oblong shaped washer that fits inside one of the backing plate holes that sets the position. My bike never had that washer. there is a marked line on the backing plate that lines up with nothing on the case. Anyone have a picture of the correct position of the plate or suggestions where I should start? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
restoring a 2000 XC300 | Adam500 | Enduro Chassis & Body | 12 | 12-19-2019 06:56 PM |
18 ignition timing. | Greatdane | Enduro Engine - 2 stroke | 0 | 05-23-2019 09:47 PM |
Gasgas timing and ignition/ electrical | Middithegasgas | Enduro Electrical & Wiring | 6 | 05-21-2018 05:17 PM |
2000 xc300 | Jeremyxc300 | Used Bikes | 1 | 03-17-2014 06:37 PM |
EC300 -2011 ignition timing | FinGas | Enduro Electrical & Wiring | 9 | 04-10-2012 06:30 AM |