|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
11-22-2011, 12:26 PM
|
|||
|
|||
Cylinder mounting studs
is there any need for the small turned diameter on the end of the m10 stud which holds the barrel to the bottom end? Its the threaded end which screws in the bottom of the engine not the part with the nuts on? Any help would be appreciated
Cheers Luke 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Setting new cylinder studs - torque | motogroove | Enduro Engine - 2 stroke | 3 | 07-20-2011 02:04 AM |
| ECU mounting | GavGav | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 05-20-2011 07:03 PM |
| Oil in front studs | steve | Enduro Engine - 2 stroke | 1 | 03-13-2008 11:05 AM |
| ec fuel tank studs | moff747 | Enduro Chassis & Body | 3 | 01-27-2008 09:35 PM |
| Studs for snow/ice tires | MattR | General Discussions & Announcements | 16 | 12-12-2006 07:47 AM |
Threaded Mode