|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Throttle Cable Mishaps
Well here's a good newbie screwup for sure. I managed to break the angled piece that screws into the carb cap on my 01 300. I was putting the tank back on and wasn't paying attention and bent the piece. We all no what happened when I tried to bend it back,snap. Is it possible to desolder the cable and purchase the angled piece, or do you have to buy a new cable? I'm going to try the local dealer tomorrow as I couldn't find any illustrations at gofasters that would tell me if the piece is available. Any suggestions would be appreciated,thanks Carl.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
securing throttle cable | flybars | Enduro Intake/Carburetion - 2 stroke | 6 | 05-09-2010 04:29 PM |
Throttle Cable | steve | Enduro Intake/Carburetion - 2 stroke | 5 | 02-14-2009 02:39 PM |
throttle cable | steve | Enduro Intake/Carburetion - 2 stroke | 5 | 02-08-2009 06:17 AM |
Throttle cable | dave948 | Enduro Intake/Carburetion - 2 stroke | 7 | 10-10-2008 04:16 PM |
Throttle Cable Crossover | Ed Ventura | General Discussions & Announcements | 8 | 08-29-2008 05:55 AM |