#1
|
|||
|
|||
2013 to 2014 racing !
Done a few bits to the bike, its just rolled over 100 hours gave it a good going over as its been pretty trouble free so got a new piston, chain, sprockets along with greasing all the bearings etc. Seeing as the bikes done me well for 100 hours I thought I would treat it to some new plastics, 2014 racing style!!!!!!!!!! Heres to the next 100 hours!!!!!
Last edited by rubber Jonny; 04-28-2014 at 03:57 PM. |
#2
|
||||
|
||||
Nice work Johnny! These bikes take a little fiddling to get set up off the bat (a bit more than other brands), but then reward you with reliable running for many long times. My 2010 went through to 260hrs on the stock bottom (inc ALL seals) end and even then was only rebuilt as preventitive maintenance. Everything was in spec.
|
#3
|
||||
|
||||
+1 to Jake's comment - she looks great.
It's hard to believe that bike has a 100 hours on it when looking at the clutch cover; have you replaced it or is that the original? Great job man |
#4
|
||||
|
||||
Different boots/feet seem to wear things differently..
Note a very clear shot, but heres my orginal at the end of its 260hr rebuild. |
#5
|
|||
|
|||
The bike looked good before the makeover for 100 hours. Im impressed with it. Had ktm 300 before. Only thing i liked about that more than the gas was resale value!!!!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2013 or 2014 xc300? | earlystock | General Discussions & Announcements | 21 | 04-19-2014 02:36 AM |
2013 300 or 2014 300 ? | ACR Tom | General Discussions & Announcements | 10 | 02-25-2014 10:51 AM |
2013-2014 Races in Western Washington | pscook | Western United States | 2 | 12-13-2013 04:00 PM |
2013 300e racing. Ignition key bypass. Anyone? | Malamute | Enduro Electrical & Wiring | 4 | 05-17-2013 09:21 PM |
2013 250 racing 48mm fork set up | nifty nick | Enduro Suspension | 8 | 04-15-2013 03:54 PM |