|
|
|||||||
| Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
 |
|
|
Thread Tools | Display Modes |
|
#1
05-10-2013, 07:15 PM
|
|||
|
|||
Swingarm bearing depth?
I'm replacing the bearings in the underside boss of the swingarm. The ones that support the pin at the end of the linkage. The factory has set the originals to ~.214" and ~.224" in from the sides. This seems a bit generous considering that the orings are ~.138" wide. I'd expect to set them ~.150" in from the sides. Thoughts?
__________________
2011 EC250E 
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Swingarm roller bearing sizes anyone? | hillbilly | Enduro Chassis & Body | 6 | 10-15-2012 09:04 PM |
| Quick swingarm/linkage bearing change question | motogroove | Enduro Suspension | 6 | 05-16-2011 12:58 PM |
| Setting Crank/Bearing depth when assembling | CDBiker220 | Enduro Engine - 2 stroke | 10 | 02-25-2011 07:32 PM |
| Swingarm linkage/bearing kits | gasIdaho | Enduro Suspension | 1 | 02-03-2009 01:29 PM |
| Moose swingarm bearing kit - not so good... | stay_upright | Enduro Suspension | 6 | 03-03-2008 03:00 AM |
Linear Mode
