|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2012 ec300r powervalve
Hi all gassers,
I'm hoping someone is able to assist me in the removal and cleaning of my ec300r powervalve. I have been following the directions in the technical articles section on the forum to remove my powervalve and give it a clean. One thing to note so far is the top rod holding the valve in was really hard to get out. After finally getting it out I am having problems removing the valve through the exhaust outlet. I have removed the exhaust spigot but I just cant get the powervalve to pull through. I have tried applying heat to the exhaust outlet but still have not been able to pull it out. Does anyone have any suggestions?? Thanks Josh (Australia) |
#2
|
||||
|
||||
Piston to bdc, and then turn the PV flapper sideways.
|
#3
|
|||
|
|||
Thanks Jakobi, the flapper looked pretty good so I just put it all back together after cleaning the rest. Thanks for your reply. It will be good to know next time.
Cheers Josh |
Tags |
ec300 powervalve |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2012 ec300r safe temp? | Terrence R | General Discussions & Announcements | 28 | 06-05-2015 04:27 AM |
Tapping Noise when riding? EC300R 2012 | MYBOARDSNOTFLAT | Enduro Engine - 2 stroke | 10 | 04-14-2015 02:59 AM |
2012 EC300R shock bearings ? | MYBOARDSNOTFLAT | Enduro Suspension | 4 | 03-24-2015 02:02 PM |
2012 ec300r | J. JuJu | General Discussions & Announcements | 5 | 08-08-2013 09:05 AM |
2012 EC300R - Australian Dirt Bike Magazine | Jakobi | Enduro Product Reviews | 3 | 10-04-2012 08:59 PM |