|
|
|||||||
| Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-04-2008, 02:13 AM
|
||||
|
||||
Sticker sticky stuff
Some of the graphics I have got are not sticky in a couple of places and so dirt will start to get in unless I stick them down with something - what's best?
I'm thinking superglue is too hard and you wont get it off the plastic. Pritt stick is the right sort of stuff but I'm not sure it's strong enough or will stick to plasitc well... Any suggestions?
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clutch problem sticky? | dank | General Discussions & Announcements | 16 | 05-26-2010 01:20 PM |
| off sticky ignition questions | mountain thumper | Enduro Electrical & Wiring | 11 | 07-14-2009 09:24 PM |
| Request for a sticky.... | stay_upright | Enduro Intake/Carburetion - 2 stroke | 0 | 07-08-2008 07:10 AM |
| Sticky power valve?? | moff747 | Enduro Engine - 2 stroke | 9 | 12-22-2007 07:59 AM |
| Fun times with a sticky carb!?! | JoshP | Enduro Intake/Carburetion - 2 stroke | 8 | 01-28-2007 03:41 PM |
Linear Mode
