Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.

Thread Tools Display Modes
Old 10-06-2006, 04:42 PM
PEB PEB is offline
Senior Member
Join Date: Aug 2006
Posts: 1,152
Default Lower End Rebuild

I am in the middle of a full lower end rebuild on an 02 250/300 and have a couple questions;

How do I get the roller bearing race off the crank?

How do you get the bearings out of the case that don't have openings on both sides, The ignition side of the primary shaft, the h20 pump bearing and the powervalve bearing? The machinist pressing all the bearings out of my cases gave me a funny look when I asked him to remove those bearings and asked "How"

Paul B

Reply With Quote

Old 10-06-2006, 06:36 PM
gasgasman's Avatar
gasgasman gasgasman is offline
Super Moderator
Join Date: Jul 2006
Location: Pearland Texas
Posts: 4,605

Use a heat gun and heat the case up.
Then tap the case down on a solid surface, the bearing will fall out.

For the race, heat it with the heat gun (10 min or so) and use a two jaw puller.

I also use the freeze technique for reinstalling the bearings.
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
lower end question mxdj2003 Enduro Engine - 2 stroke 0 09-08-2009 05:25 PM
How can I protect my lower back? thelonius General Discussions & Announcements 10 04-30-2009 02:10 PM

All times are GMT -5. The time now is 08:39 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org