|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Interchangable rocker arm
Hi,
Hope someone can help! I recently acquired a 200 ec '06 model and have discovered that the Rocker Arm where the shock mounts to is total destroyed, any bushing/bearings that was in there are all in pieces and this has caused the hole in the rocker to become ovel in shape. I don't hold much hope trying to get this repaired... I was wondering if this http://cgi.ebay.co.uk/Gas-Gas-EC-125...item1c15ad677c would fit? I searched the gas gas es site and can't even find a manual for a 125 ec 2000 model. The Linkage repair kits you can get cover both these models with the same set so surely they must be the same? thanks |
#2
|
||||
|
||||
I don't know if they are all the same but I do have an extra rocker that will fit the older bikes. Where are you located?
|
#3
|
||||
|
||||
They should all be the same. 125 has 1mm longer pull rods, thats all.
|
#4
|
|||
|
|||
Thanks for your replies! This is good news.. I live in the UK so would probably cost a small fortune to post, but thanks anyway much appreciated
|
#5
|
||||
|
||||
Rebore the rocker arm and press in a steel bushing. I did that on mine and it works great..
__________________
Henrik Schmidt Faster, Faster!! Until the Thrill of Speed, Overcomes the Fear of Death.. Team YamaGas Racing. http://bricksite.com/teamyamagasracing |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How many O rings on the rear suspension rocker | stay_upright | Enduro Suspension | 7 | 01-15-2008 08:58 AM |