|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Dyna Ring Question
For those of you that are running Revloc Dyna Rings in your bikes, what's your setup in terms of the number of screws/springs in the Dyna Ring, as well as the gap (and spacers)?
I've had one ride with the stock setup using 3 screws/springs and it seemed fine, but it also seemed like I could get away with a lower RPM where it starts slipping. The EC300 can lug up a hill quite nicely, so it might just be wasting clutch plates if it's slipping when it doesn't need to. -Jesse |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Revloc Dyna Ring | MonsterTruck | Enduro Product Reviews | 10 | 04-18-2011 07:24 PM |
dyna ring install ? | jhendr3702 | General Discussions & Announcements | 13 | 02-17-2011 03:29 PM |
Questions about Dyna Ring | bukwheat | General Discussions & Announcements | 3 | 02-08-2011 12:05 PM |
Revloc Dyna Ring | ducrider | Enduro Product Reviews | 2 | 09-20-2010 03:08 AM |
Ring Question | PEB | Enduro Engine - 2 stroke | 4 | 02-14-2008 01:10 PM |