|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#20
|
||||
|
||||
What 2T oil are you using in your gasoline? We have found some "lesser known" oils will cause the motorcycle to run poorly at low engine speeds. Motul at 50:1 always runs well for us.
Another issue we have had is with older filters breaking down and obstructing air flow and/or holding on to water after washing the motorcycle. Check your filter and maybe try starting with the filter off the motorcycle (do not ride it without the filter). The final issue we have had is after washing or riding through water, electrical connections get contaminated with water. Check each connection, clean with a spray electrical contact cleaner, and use dielectric grease to properly reconnect. One rider in our group had an electric horn go bad and the bike would not start. Good luck!
__________________
2018 GG 300 GP 2014 GG 300 Racing E 2002 ATK 605 Dual Sport 2003 KX/KDX 220 hybrid 2021 Kawasaki KRX 1000 Trail Edition 1974-86 Vintage Can Ams, SWMs, Puchs, etc. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
needle advice | skippyjlo | Enduro Intake/Carburetion - 2 stroke | 9 | 11-11-2016 06:46 PM |
Keihin PWK needle jet size? (not the needle it self) | David v | Enduro Intake/Carburetion - 2 stroke | 3 | 12-05-2014 08:16 AM |
JD blue needle jetting advice AS1 carb | nknudsen | Enduro Intake/Carburetion - 2 stroke | 1 | 03-12-2014 11:28 AM |
ec 300 cck needle | alun | Enduro Intake/Carburetion - 2 stroke | 3 | 12-29-2011 02:53 PM |
Needle advice EC250 | darren | Enduro Intake/Carburetion - 2 stroke | 0 | 06-19-2009 03:00 PM |