New 2022 300 Ranger

[Moto7man]

Rear Tubliss was fairly easy to install. When I wear out the Michelin tires I will probably go to a Mitas. I have two new ones sitting in corner of the garage.

[Moto7man]

I safety wired the grips.

[Moto7man]

I removed the stock display and mounted a trailtech voyager with the protector. One nice thing is the Ranger came with pickup on the front disc and front electric connector that plugs directly into the trailtech, just plug and play.

[Moto7man]

Trailtech doesn't sell the gps cables any more but they sent me a link at amazon. This cable was about $15.00

[Moto7man]

I installed the garmin as a back up in case my voyager goes dead on me out in the boonies.To add this I removed the cross bar from my renthal handlebars. One other thing, look carefully at the throttle cable, shouldn't that cable be routed in front of the triples and back under the tank?

[SS109]

Bike is looking sweet!

On that throttle cable, a buddy got a new MR300 and his cable was routed the same. Seems really odd to me and, if the cable is long enough, I would reroute it.

[Moto7man]

Originally Posted by SS109

Bike is looking sweet!

On that throttle cable, a buddy got a new MR300 and his cable was routed the same. Seems really odd to me and, if the cable is long enough, I would reroute it.

Ok, I might try to reroute it. Thanks. Does anyone know where I can get an aluminum skid plate? I think a 2018 or 2019 gasgas skid plate would work and a used one would be just fine. I bought a new one but it is on backorder.

[SS109]

I know it's not aluminum but TM Designs and AXP Racing have "plastic" skip plates available. I actually prefer them over the aluminum as they are quieter and actually let you slide over rocks and trees instead of dragging across them. I put a TM version on my '11 EC250 and it has proven much better than the aluminum one I had on there.

[Moto7man]

Originally Posted by SS109

I know it's not aluminum but TM Designs and AXP Racing have "plastic" skip plates available. I actually prefer them over the aluminum as they are quieter and actually let you slide over rocks and trees instead of dragging across them. I put a TM version on my '11 EC250 and it has proven much better than the aluminum one I had on there.

Thanks, I had seen those.Would you go with the 6mm thick std MX model, or the 8mm extreme model?:

[pigpen966]

I replaced the stock cable with the Motion Pro and it was a HUGE improvement over the stock cable. was a couple inches longer so I was able to route it in front of the bars.