|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
300 hard starting warm Having some carb issues.
I have a 2011 300 . All electrical is working fine.
I picked this bike up, left it in the basement for 2 months and then went to an enduro. I had a long day. Bike was pig rich. And Very hard to start warm. Like let it sit 10 minutes then start it. 35 f 20 % humidity Got home found 36mm ASII 6.5 Slide NOZH 3rd 40 Pilot 178 main Air screw No effect. FLoat 6.5 I lowered the float to 8mm. It seem to help starting but ran still to rich. No Power. A little bit of change with Air Screw I just installed a # 7 slide that is From My RB modded A.S.I It Runs Much better. Very Crisp. Will need g2 Throttle cam for tight single track. BUT""" Air Screw has no effect. Even with idle screw out. Idles great. If shut it off sometimes it starts good , sometime it takes 20 kicks Todays Weather 55 F 20 % humidity Ed
__________________
2011 Sixdays 300 Last edited by Ed Ventura; 03-11-2012 at 08:27 PM. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Extremely hard starting problems | Crankin04 | Enduro Engine 4 stroke (including EFI & Exhaust) | 27 | 01-11-2021 02:12 AM |
Carb issues - Float bowl? | Hicksi | Enduro Intake/Carburetion - 2 stroke | 7 | 10-19-2011 11:21 AM |
04 EC 300 Hard Starting | lordfeyr | Enduro Engine - 2 stroke | 4 | 01-25-2010 01:18 PM |
2004 450 FSE Hot Starting Issues- | MTNBK | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 06-30-2009 07:19 AM |
Hard starting - Timing change? | mattmax | Enduro Engine - 2 stroke | 14 | 03-03-2007 01:03 PM |