|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
I had to go back out and see him today, the shims he have me were 6mm ID... No dramas new 8mm ID shims swapped over.
While I was there I spoke to him about the shock and showed him the rest of the video. He is of the opinion that the LSC is a bit soft causing it to ride low in the stroke, any HSC impacts during this causes it to blow through and hit the bump stop causing the kick in the pants I've been getting. His recommendation was to add a few clicks of LSC and see how it goes which was my plan anyway. But since I was there I got curious and asked about the rear spring, currently with a 6.0 and 13mm preload I end up with 25mm static/98mm race. He advised that I could continue to use the current spring, however ideally going up a rate or two would benefit me as it would encourage the rear to sit up and the stroke and I'd be able to keep the LSC clickers where they are. He must of felt sorry for me because he gave me a great discount on a new 6.4 spring. I guess this means I'm now officially a fat arse
__________________
Current: 2014 Gas Gas EC300R _____________________________________________ Previous: 2011 Gas Gas EC300 ELC 2004 KTM 300 EXC |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Slo Mo suspension | Fred1956 | Enduro Suspension | 12 | 03-28-2014 02:46 AM |
help with 03 200 suspension | XR250R64 | General Discussions & Announcements | 0 | 09-10-2012 07:20 AM |
same suspension ec 200 and ec 300? | hannesd | Enduro Suspension | 3 | 05-13-2012 04:18 PM |
EC 200 Suspension | Gas Huffer | General Discussions & Announcements | 3 | 11-13-2007 10:34 AM |
Suspension FAQ | webmaster | Enduro Suspension | 12 | 09-18-2006 03:56 PM |