|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
01-19-2019, 06:27 AM
|
|||
|
|||
EC 300 2012 idle revs remain high
When started, it keeps rpms higher than normal for idle. Than I put it in gear, and release the clutch slowly with the brake on. Rpms drop to normal and stays low (I switch to neutral). Than I open the throttle for a sec and idle remains high again. The mixture screw is one turn out. I don't know what is inside the Keihin, I bought the bike a month ago and haven't had a chance to test it due to bad weather until now. Made few circles only on a field nearby and it pulls well, but whenever switched to neutral and rewed for a sec, revs stays high.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need to Mellow WOT Power at high revs | stay_upright | Enduro Intake/Carburetion - 2 stroke | 15 | 09-25-2017 06:16 PM |
| Overheating on high load and revs only, what could it be ? | poelinca | Enduro Engine - 2 stroke | 18 | 07-11-2017 05:45 AM |
| Really sputters at high revs now | motopsycho87 | Enduro Electrical & Wiring | 11 | 11-14-2013 02:04 PM |
| Engine won't run at high revs | motopsycho87 | Enduro Engine - 2 stroke | 36 | 08-28-2013 04:37 PM |
| Sputters at high revs... | motopsycho87 | Enduro Electrical & Wiring | 9 | 06-21-2013 10:12 PM |
Threaded Mode