|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Anyone else ever broken an air screw?
Hello All,
Longtime lurker, Ever since I bought my '01 250 xco I have been unable to adjust my airscrew. It has always been turned all the way in and will not budge. Well after installing the LTR needle the other day I was determined to loosen up this seized screw. To no avail I broke off the head!!! Any ideas on how to get it out and replaced? Also the flexible air boot that the backside of the carbbie goes into needs to be replaced as the rubber is somewhat dried out and flaking. Anyone have this problem? Thanks Tim |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
pilot jet vs. air screw question | stainlesscycle | Enduro Intake/Carburetion - 2 stroke | 4 | 06-27-2010 02:51 PM |
Help with air screw setting on RB-carb | joey11 | Enduro Intake/Carburetion - 2 stroke | 7 | 02-17-2009 07:09 AM |
clutch bleed screw | Oldcow | General Discussions & Announcements | 2 | 07-19-2008 06:01 AM |
Stripped screw in gas tank | prk03 | General Discussions & Announcements | 2 | 06-18-2008 11:19 AM |
200 with screw in the crank???? | ramcclure200 | Enduro Engine - 2 stroke | 3 | 05-03-2007 11:42 PM |