|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
rekluse core manual question??
does any one know the sequence of drive and fibre plates with the core manual? i can't find my manual and online can't find it either. i believe it goes thin steel drive plate first(.040)then fibre, steel and ends with a fibre using 7 of the thicker (.060) drive plates and 8 total fibres. can anyone confirm this or show me there manual they got with theres? much appreciated for any help trying to get out riding tomorrow !
__________________
trevor |
#2
|
||||
|
||||
Quote:
Trev Did you get it figured out?
__________________
2012 - XC 300 Racing Seattle, WA |
#3
|
||||
|
||||
Not sure stu I put it in like I said but haven't started it up cause my boys are napping! I haven't ridden in over 3 months and took the bike out 2 days ago for a rip and the clutch wouldn't engage. Big waste of a trip so I tore the new clutch down and turns out I forgot the bloody thrust washer between basket and clutch hub! Then I couldn't remember if the clutch pack was correct. Getting old sucks my bloody memory is shot
__________________
trevor |
#4
|
||||
|
||||
Trev - I just sent you an email to your email account.
Check it out and see if that helps you out?
__________________
2012 - XC 300 Racing Seattle, WA |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Looking for a Rekluse Core EXP | myrcrocks | "Wanted to Buy" & "Want To Trade" | 7 | 02-03-2014 11:06 AM |
Rekluse Core EXP Install Question | TavisB | Enduro Engine - 2 stroke | 11 | 06-09-2012 06:33 PM |
USED Value Rekluse Core EXP 2.0 | roverhybrids | General Discussions & Announcements | 3 | 02-23-2012 09:27 PM |