|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Tiny ball bearings found in oil change
Hey y?all,
I bought a leftover 2021 mr300 a year ago that now has over 180 hours. It has been a wonderful bike but I found something concerning yesterday. I pulled my magnetic oil drain plug and found a few ball bearings and a cage and attached to it. Bike has been running fine, no weird sounds, plenty of power (not that I ever use it) , no overheating and it shifts well so I can?t imagine where to start looking for this. Cage is 10mm OD and the balls are 1mm in diameter Any ideas? Last edited by Slagathor; 07-17-2023 at 02:52 PM. Reason: Added sizes for Bb and try to get the pictures to show up |
#2
|
|||
|
|||
|
#3
|
|||
|
|||
|
#4
|
||||
|
||||
How did you find the cage?
Anyway, the only small caged bearings I recall are for the water pump and the powervalve governor. I'm sure it's one of the two.
__________________
WildAzzRacing YouTube channel Trail Riders of Southern AZ club AZ State Parks OHV Ambassador '11 EC250R '98 KDX220 |
#5
|
|||
|
|||
It was stuck to the magnetic drain plug!
I found a post from 2011 that describes similar sized bearings but they never found an answer https://share.icloud.com/photos/05ay...kx9qzENEmWHR6w |
#6
|
||||
|
||||
Well, you are going to have to pull the inner clutch cover to find out.
__________________
WildAzzRacing YouTube channel Trail Riders of Southern AZ club AZ State Parks OHV Ambassador '11 EC250R '98 KDX220 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TM = Tiny motor- Thrill machine | Stoby | All Other Bikes... | 3 | 05-11-2022 10:27 AM |
ec 250 power valve governor what year gg did change from 4 ball to 6 ball | rvktm | Enduro Engine - 2 stroke | 3 | 04-16-2020 05:49 PM |
Kickstarter - tiny parts | Mikeyx | Enduro Chassis & Body | 0 | 04-28-2018 01:28 PM |
Gasser have found the ball | TooFastTim | General Discussions & Announcements | 2 | 08-04-2008 02:56 PM |