Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 03-28-2009, 07:53 AM
prk03's Avatar
prk03 prk03 is offline
Gold Level Site Supporter
 
Join Date: Jul 2006
Location: Alabama
Posts: 55
Default 07 250 Kick Starter

There is some play where the kick starter attaches to the spindle. The bolts are tight but don't prevent the play. There is no slippage around the spindle and the bike starts OK but sooner or later I see a problem that it might. Please look to see how much play your bike may have. If others are tight without play I will probably get new spindle and /or kick starter. I looked at the grooves on each part and they look OK.


Reply With Quote


  #2  
Old 03-28-2009, 08:24 AM
GMP's Avatar
GMP GMP is offline
Senior Member
 
Join Date: Jul 2006
Location: Jefferson Twp., NJ
Posts: 7,597
Default

The shaft has a slight taper in the spline cut, and the starter knuckle should sit a bit less than flush when mounted. If it doesn't, use a shim so that you can tighten the starter back against the taper. When using a KTM starter (they fit too) the fit is a bit sloppy like this and this fix works. I beleive the shim I used was 17mm ID, but check the shaft OD. This may get you by.
Reply With Quote
  #3  
Old 03-28-2009, 10:59 PM
vfrrocks's Avatar
vfrrocks vfrrocks is offline
Gold Level Site Supporter
 
Join Date: Dec 2007
Location: West Virginia
Posts: 18
Default kick lever shim

hi,
Had the same problem that i was able to correct today. As GMP stated i cut a small shim approx. 3mm to take up the space between lever body and the shaft end, worked like a charm. also i found that a old wrist pin bearing from a KX250 has the right O.D and I.D. to make a shim from.
__________________
you don't have to live on the edge, just know where it is.
____________________
Ken
05 GasGas EC300
05 Honda CRF450X
98 Honda VFR800
89 Honda RC31
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
kick starter help jhendr3702 Enduro Engine - 2 stroke 13 12-09-2011 11:13 PM
Kick Starter ? rockrider1 General Discussions & Announcements 1 11-04-2010 08:49 AM
Kick starter? 2 strokes 4 life Enduro Engine - 2 stroke 2 09-08-2008 09:47 PM
Kick starter probs peterr Enduro Engine - 2 stroke 4 10-03-2007 05:36 AM




All times are GMT -5. The time now is 10:06 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org