|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#21
|
||||
|
||||
Thanks. I have a set of Moose hybrid pegs that I haven't installed yet, but I know from looking they are some bit wider. Not sure if they are 57mm wide, but bigger than stock. I'll take that into consideration and probably go with the +15 then. 15mm which is like .6 inches.
Never dealt with Smiths. They give discounts for forum members?
__________________
2011 Gas Gas EC300 38mm, 2008 Husky TE610, 2003 Beta Rev3 250 |
#22
|
||||
|
||||
No, but they have fair prices, excellent stock, and have supported the brand well.
|
#23
|
|||
|
|||
I too am using the moose hybrids. I got the 1/2 inch offsets.
__________________
2018 XC300 |
#24
|
||||
|
||||
Stock Shifter Length Solution
The shift lever through '10 is ME120336026. The same shifter is listed as an optional part on the 2011s, with the "short gear lever set" ME250036026 offered as standard.
Those of you (on new bikes) that pine for the good old days when men were men and they had big feet may want to order up the longer piece.
__________________
Steven Beane #275 PlusOnePerformance - Superior Service the World Over - Dearborn MI AMA District 14 (Michigan) Officer afterhourscycle.com Michigan's Beta and TM Race Headquarters |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hammerhead Designs GG shifter | AZRickD | Enduro Product Announcements | 19 | 08-15-2011 09:06 AM |
Hammerhead Shifter bolt | Brian | Enduro Chassis & Body | 20 | 04-22-2011 09:55 PM |
Hammerhead shifter | steve | Enduro Product Reviews | 0 | 02-04-2009 05:32 AM |
Spring length question | Bandit9 | Enduro Suspension | 4 | 06-26-2007 05:22 PM |
Gear lever length ???? | pyroman | General Discussions & Announcements | 3 | 05-16-2007 07:59 AM |